Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
AS A 1997 CONTROLLER. MDS AUTOMATED DIAGNOSTICS FOR THE AFFECTED VEHICLES TEMPORARILY WILL NOT WORK.
1.
Connect the MDS (Mopar Diagnostic System) and DRB III (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 MDS DIAGNOSTICS on the DRB III MAIN MENU Screen.
3.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
4.
Use the arrow keys and select VEHICLE CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select PROGRAMMING OF ALL OTHER CONTROLLERS USING MDS & DRBIII on the MDS, then press NEXT
MENU.
6.
Follow the steps presented on the MDS and DRB III which will allow the DRB III to obtain the current part number of the PCM.
7.
The MDS will display the part number of the PCM on the vehicle and the appropriate replacement part number, then press NEXT MENU to begin
programming.
If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the part
number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another condition
exists that will require further diagnosis and repair.
8.
The MDS and DRB III will prompt for any operator action needed during the remainder of the programming process.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
9.
Type the necessary information on the "Authorized Software Update Label" p/n 4669020. Attach the label to the PCM and cover the label with the
clear plastic overlay.
10.
Type the necessary information on the Authorized Modification Label and attach the label near the VECI Label.
11.
Remove and discard the brake switch on JA/JX models and replace the switch with p/n 04671336.
NOTE:
THE BRAKE SWITCH USED IS A 1997 MODEL YEAR PART.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-48-92
0.5 Hrs.
Module, Powertrain Control Reprogram
