Sebring Convertible V6-2.5L VIN H (1997)
Brake Pedal Holding Tool Installed
3. Using a brake pedal positioning tool such as shown depress brake pedal past its first 1 inch of travel and hold in this position. This will isolate the
master cylinder reservoir from the brake hydraulic system, not allowing the brake fluid to drain out of the reservoir.
4. Raise vehicle on jackstands or center on a hoist.
5. Using Mopar, Brake Parts Cleaner or an equivalent, thoroughly clean all surfaces of the Hydraulic Control Unit (HCU). Also, thoroughly clean all
brake line tube nut to HCU and proportioning valve connections.
Exhaust Pipe Mounting To Exhaust Manifold
6. Remove the entire exhaust system from the vehicle as a complete assembly using following steps.
^
Remove attaching bolts from exhaust pipe at exhaust manifold on engine.
Exhaust System Support/Isolators Locations
^
Remove all exhaust system support/isolators from the vehicle's exhaust system. Remove support/isolators from brackets on exhaust system
components and leave attached to body of vehicle.
^
Lower exhaust system as a complete assembly away from the underbody of the vehicle.
