Sebring Convertible V6-2.5L VIN H (1997)
tubes so the outlets of the bleeding tubes will be below the surface of the brake fluid when reservoir is filled to proper level.
2. Fill brake fluid reservoir with brake fluid conforming to DOT 3 specifications such as Mopar or an equivalent.
3. Using a wooden dowel. Depress push rod slowly, and then allow pistons to return to the released position. Continue to repeat this step several
times after no more air bubbles are expelled from bleed tubes to ensure all air is bled from the master cylinder.
4. Remove bleeding tubes from master cylinder outlet ports, plug outlet ports and install fill cap on reservoir.
5. Remove master cylinder from vise and install master cylinder into vehicle.
6. Bleed the entire hydraulic system.
Manual Bleeding
Air Trapped In Brake System
Method For Purging Air From Brake System
Bleeder Screw
CAUTION:
-
Before removing the Master Cylinder cover, wipe it clean to prevent dirt and other foreign matter from dropping into the master cylinder.
NOTE:
