Sebring Convertible V6-2.5L VIN H (1997)
Center Console Front Attaching Screws (Automatic)
3. Remove the 2 screws attaching the center console to the shifter.
Center Console Rear Attaching Screws
4. Remove the 3 screws attaching the rear of the center console to the console bracket.
5. Raise the park brake lever to a 45 degree angle. This is required for clearance to remove the center console.
Console Wiring Harness Connector
6. Raise the rear of the center console high enough to access the center console wiring harness connector. Disconnect the center console wiring
harness connector from the vehicle wiring harness 10-way connector.
7. Remove the center console from the vehicle.
8. Lower the park brake lever to its fully released position.
WARNING: THE AUTO ADJUSTING FEATURE OF THIS PARK BRAKE LEVER CONTAINS A CLOCK SPRING LOADED TO
APPROXIMATELY 20 POUNDS. DO NOT RELEASE THE PARK BRAKE CABLES FROM THE EQUALIZER UNTIL THE
AUTO ADJUSTER IS RELOADED. FAILURE TO RELOAD THE ADJUSTER MECHANISM BEFORE REMOVING PARK BRAKE
CABLES FROM EQUALIZER COULD RESULT IN SERIOUS INJURY.
