chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Engine - Rough Idle, Hard Start, or Start & Stall|Page 3421 > < EGR Tube|Specifications|Page 3416
Page 1
background image

EGR Valve: Technical Service Bulletins
Engine - Rough Idle, Hard Start, or Start & Stall

NUMBER: 18-020-01

GROUP: Vehicle Performance

DATE: Aug. 17, 2001

SUBJECT:
Rough Idle, Hard Start, Start & Stall

OVERVIEW:
This bulletin involves installing a revised EGR valve.

MODELS:

1995 - 2000

(JA)

Breeze/Cirrus/Stratus

1996 - 2000

(JX)

Sebring Convertible

NOTE:

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 2.5L ENGINE.

SYMPTOM/CONDITION:

Vehicle may intermittently exhibit any of the following conditions:

^

Rough engine idle.

^

Hard start or long crank after hot soak.

^

Start and stall when started with cold engine

^

Diagnostic Trouble Code (DTC) P0300, Multiple Cylinder Mis-fire.

DIAGNOSIS:

Using the Diagnostic Scan Tool (DRB III(R)) with the appropriate Diagnostic Procedures, verify all engine/transmission systems are functioning as
designed. If other DTC's are present, record them on the repair order and repair as necessary before proceeding further with this bulletin. If the
condition(s) can be duplicated or is described by the customer, it may be caused by the EGR valve being stuck partially open. To confirm whether or not
the valve is stuck partially open:

1.

If the condition(s) can be duplicated, then block off the EGR passageway to the intake manifold. If the condition(s) disappear, but will reappear
when the EGR passageway is re-opened, perform the Repair Procedure.

2.

If the condition(s) cannot be duplicated, but are described by the customer, perform the Repair procedure.

PARTS REQUIRED:

REPAIR PROCEDURE:

Install the revised EGR valve as described in the appropriate Service Manual.

POLICY:
Reimbursable within the provisions of the warranty.

Engine - Rough Idle, Hard Start, or Start & Stall|Page 3421 > < EGR Tube|Specifications|Page 3416