Sebring Convertible V6-2.5L VIN H (1997)
Starter Motor: Service and Repair
CAUTION: The generator output terminal must be connected to the battery positive terminal of the starter solenoid. For the charging and cranking
systems to operate properly.
REMOVAL
Remove Remote Battery Cable At Shock Tower
1. Disconnect battery negative cable from remote negative terminal on shock tower.
2. Raise vehicle.
3. Remove oil filter.
Wire Terminal Connection - 2.5L Engine
4. Remove battery positive cable nut from starter and remove cable.
5. Disconnect push on solenoid connector.
6. Remove three bolts attaching starter to transmission housing and remove starter from vehicle.
INSTALLATION
-
For installation, reverse the above procedures. Clean corrosion/dirt from wire terminals before installing wiring to the solenoid.
