Sebring Convertible V6-2.5L VIN H (1997)
steering fluid reservoir. Be sure hose clamp is installed on supply hose past the upset bead on power steering fluid reservoir.
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R), Power Steering Fluid, or equivalent.
4. Fill power steering fluid reservoir.
5. Start the engine and let run for a few seconds. Then turn the engine off.
6. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
7. Raise front wheels of vehicle off the ground.
8. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops. Then turn the engine off.
9. Add power steering fluid if necessary.
10. Lower the vehicle and turn the steering wheel slowly from lock to lock.
11. Stop the engine. Check the fluid level and refill as required.
12. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
13. After hose is-installed, check for leaks at all hose connections.
