Sebring Convertible V6-2.5L VIN H (1997)
7. Attach the power steering pressure hose to the outlet fitting on the power steering pump. Do not tighten the pressure fitting banjo bolt at this time.
CAUTION: Hoses must remain away from exhaust system, vehicle components and unfriendly surfaces causing possible damage to power steering
hoses.
8. Correctly route power steering pressure hose avoiding tight bends or kinking of the hose. Install power steering pressure hose routing brackets and
attaching bolts on engine.
9. Route power steering pressure hose to pressure port on power steering gear. Install power steering pressure hose, on steering gear and loosely install
tube nut into steering gear. Then using a crow foot, tighten the power steering pressure hose tube nut to a torque of 31 Nm (275 inch lbs.).
10. Correctly position the power steering pressure hose banjo fitting at the power steering pump so the power steering pressure hose is not touching any
components or the body. While holding the banjo fitting from rotating, tighten the Banjo Bolt to a torque of 34 Nm (25 ft. lbs.).
CAUTION: When installing the front suspension crossmember, it must be installed back in the same location on the vehicle's body as when it was
originally installed when the vehicle was built.
