Sebring Convertible V6-2.5L VIN H (1997)
6. Remove the 2 routing brackets attaching the power steering return hose to the power steering pressure hose routing brackets.
7. Remove the power steering return hose from the vehicle. The power steering return hose is removed from the bottom of the engine compartment.
Installation
1. Install power steering return hose on vehicle. Power steering return hose is installed from the bottom of the vehicles engine compartment using the
reverse steps of removal.
2. Using a lint free towel, wipe clean all open power steering hose ends, and the power steering gear port.
3. Install a new O-ring on the power steering return hose to steering gear fitting.
4. Lubricate O-ring using fresh clean power steering fluid.
5. Install the power steering return hose, on the cooler lines.
CAUTION: Hoses must remain away from exhaust system, vehicle components and unfriendly surfaces causing possible damage to power steering
hoses.
6. Correctly route power steering return hose up to the power steering fluid reservoir, avoiding tight bends or kinking of the hose.
