Sebring Convertible V6-2.5L VIN H (1997)
Power Steering Pump: Service and Repair
Power Steering Pump Flow Control Valve Seal Replacement
DISASSEMBLE
The power steering pump does not require removal from the engine for removal and replacement of the flow control valve fitting O-Ring.
Fig. 2
1. Remove the power steering fluid pressure hose from power steering pump pressure fitting.
2. Remove the power steering pump discharge/flow control valve fitting from the power steering pump housing. Use care to prevent the flow
control valve and the spring from sliding out of the discharge/flow control valve fitting.
3. Remove and discard O-ring seal from fitting.
ASSEMBLE
1. If necessary, clean and install flow control valve and spring in pump housing bore.
2. Install new O-ring seal on fitting.
3. Install the discharge/flow control valve fitting into the power steering pump. Tighten the discharge/flow control valve to a torque of 75 Nm (55 ft.
lbs.).
4. Install power steering fluid pressure hose on flow control valve fitting. Tighten the banjo bolt to a torque of 34 Nm (25 ft. lbs.).
