Sebring Convertible V6-2.5L VIN H (1997)
9. Remove bolt at adjusting slot in accessory drive mounting bracket, attaching back of power steering pump to the bracket.
10. Remove bolt at adjustment slot, attaching the power steering pump front mounting bracket to cast aluminum accessory drive bracket on engine.
Then remove bolt at top of power steering front mounting bracket, attaching it to the accessory drive bracket.
11. Remove the 2 upper, and 1 lower, bolts fastening the accessory drive bracket to the rear of the engine. Allow bracket to move freely away from the
pump.
12. Remove drive belt from the pump pulley, then remove power steering pump, fluid supply hose and front mounting bracket as an assembly from the
engine and vehicle. This assembly is removable by rotating it out through the area between rear of engine, driveshaft and front suspension
crossmember.
13. Transfer required parts from removed power steering pump, to replacement power steering pump.
Suction Port Fitting Replacement
NOTE: The power steering pump will require removal from the engine for removal and replacement of the suction port O-Ring seal.
