Sebring Convertible V6-2.7L (2009)
1. Position the headliner (2) and secure the lower retainer along the bottom edge of the backlite (3).
2. Release the plastic retainers on the sides and top of the backlite.
3. Connect the heated backlite electrical connectors.
4. Install the push pin type retainers across the top of the backlite.
5. Install the fasteners mounting the headliner to the rear glass top panel.
6. Connect the elastic straps at the side rails.
7. Install the fasteners securing the elastic straps to the rear panel.
8. Secure the "J" strips at the # 1, 2 and 3 bows (5 and 4).
9. Secure the "J" strip at header.
10. Install the header (6) and side rail trim panels.
11. Close the convertible top.
