Sebring Convertible V6-2.7L (2009)
10. Lower the top to the header, do not latch.
11. Remove the forward mounting fastener (3) on each side.
12. Remove the rearward mounting fastener (4) on each side.
13. With help from an assistant, carefully remove the front panel from the vehicle.
14. Remove the mid/rear headliner. See: Interior Moulding / Trim/Headliner/Service and Repair/Convertible Soft Top Unique
Components/Convertible Top Headliner - Removal.
15. Disconnect the micro-switch connectors (2 and 5).
16. Remove the push-pins (3) securing the harness to the middle panel.
17. Remove both clips (4) from the panel to panel cylinder.
18. Disengage the latch cable (1) from the support and remove from the panel to panel latch.
19. Disconnect the drain tube to gain access to the mounting fasteners (2).
20. Make note of the location, quantity and size of the shims located between the side rail and middle panel to aid in installation at each fastener.
21. Remove the lower two fasteners on each side.
22. With the help of an assistant, remove the top fastener on each side and remove the mid panel (1) from the vehicle.