Sebring Convertible V6-2.7L (2009)
23. Mark the location of the hinge bracket to rear panel (4) to aid in installation.
24. Disconnect the heated glass connectors (3) and remove the harness from the rear panel.
25. Remove the lower fastener (2).
26. Remove the two lower fasteners (1), leaving the top one on each side, that secure the rear panel to the hinge assemblies.
27. With the help of assistant, remove remaining fasteners and remove rear panel.
28. Remove the center rail weatherstrips and retainers.
29. Make marks with a scribe or grease pencil to align the primary hinge (2) upon installation.
30. Remove the bolts (1) to the hinge and remove from vehicle.
