Sebring Convertible V6-2.7L (2009)
12. Engage the latch cable (1) to the support and install to the panel to panel latch.
13. Install both clips (4) to the panel to panel cylinder.
14. Install the push-pins (3) securing the harness to the middle panel.
15. Connect the micro-switch connectors (2 and 5).
16. Install the mid/rear headliner. See: Interior Moulding / Trim/Headliner/Service and Repair/Convertible Soft Top Unique Components/Convertible
Top Headliner - Installation.
17. With help to an assistant, carefully install the front panel to the vehicle.
18. Install the rearward mounting fastener (4) on each side. Tighten to 10 N-m (7 ft. lbs.).
19. Install the forward mounting fastener (3) on each side. Tighten to 10 N-m (7 ft. lbs.).
20. Connect the cable (2) to the top panel linkage.
21. Engage the cable retainer (1) to the top panel.
22. Install the hinge covers.
23. Install the front headliner. See: Interior Moulding / Trim/Headliner/Service and Repair/Convertible Soft Top Unique Components/Convertible Top
Headliner - Installation.
