Sebring Convertible V6-2.7L (2009)
Deck Bar Cylinder Position
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Conventionally open the rear decklid.
3. Remove the rear trunk trim panel.
4. Remove the left trunk trim panel.
5. Disconnect the deckbar cylinder (1) position switch electrical connector (3).
6. Using a small flat bladed screwdriver or other suitable tool, gently slide the position switch retainer locking tab (1) away from the retainer (4).
7. Slide the position switch retainer (4) away from the switch (2).
8. Lift the position switch (2) off of the deckbar cylinder (3).
9. Disconnect any position switch wire harness routing clips and remove the switch from the vehicle.
Decklid Latch Limit
REMOVAL
