Sebring Convertible V6-2.7L (2009)
10. Using an 1/8 in. drill bit, drill out the rivet (1) securing the switch (4) to the decklid forward latch (2). Lift the switch upward to release the
retaining tab (3) and remove the switch from the latch (2).
Luggage Protector Position
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the rear decklid.
3. Remove the rear trunk trim panel.
4. Remove the right trunk trim panel (2).
5. Disconnect the luggage protector position switch electrical connector (4).
6. Remove the switch retaining screws (5).
7. Separate the switch (1) from the trim panel (2).
Stack Cylinder Position
REMOVAL
