Sebring Convertible V6-2.7L (2009)
3. Secure the position switch to the deckbar cylinder. Position the switch on the underside of the cylinder and push the switch retainer over the
switch. Push the position switch retainer locking tab towards the retainer until the two are fully engaged.
4. Connect the position switch (2) wire harness routing clips to the left inner quarter panel.
5. Connect the deckbar cylinder position switch electrical connector (3).
6. Install the left trunk trim panel.
7. Install the rear trunk trim panel.
8. Close the rear decklid.
9. Connect the battery negative cable.
Decklid Latch Limit
INSTALLATION
1. Position the decklid latch limit switch (4) onto the decklid forward latch assembly (2). Ensure the switch retaining tab (3) is inserted into the slot
on the latch (2).
2. Install the switch retaining rivet (1).
