Sebring Convertible V6-2.7L (2009)
1. Position the luggage protector position switch (1) onto the right trunk trim panel (2). Ensure the switch sensing tab (3) is located in the trim panel
slot.
2. Install the two retaining screws (5).
3. Connect the switch electrical connector (4).
4. Install the right trunk trim panel.
5. Install the rear trunk trim panel.
6. Close the rear decklid.
7. Connect the battery negative cable.
Stack Cylinder Position
INSTALLATION
1. Position the folding top stack cylinder position switch (2) onto the folding top stack cylinder (3).
2. Secure the position switch to the folding top stack cylinder. Push the switch retainer (4) over the switch (2). Push the position switch retainer
locking tab (1) towards the retainer (4) until the two are fully engaged.
