Sebring Convertible V6-2.7L (2009)
8. If the mounting bracket (3) needs to be installed on the ICU (1), install the mounting pins in the ICU as necessary and tighten to 11 Nm (97 in.
lbs.). Insert the mounting pins into the grommets mounted in the bracket, then install the single mounting bolt (2). Tighten the mounting bolt to 11
Nm (97 in. lbs.).
9. Install the ICU in the vehicle. See: Removal and Replacement/Integrated Control Unit (ICU) - Installation
Integrated Control Unit (ICU) - Disassembly
DISASSEMBLY
NOTE: For vehicles equipped with Hill Start Assist (HSA), the ICU must be serviced as an assembly. The HCU and ABM are not serviceable
separately.
1. If the mounting bracket (3) needs to be removed from the ICU, remove the single mounting bolt (2), then slide the ICU's mounting pins out of the
grommets in the bracket and remove the bracket.
2. Remove the mounting pins from the ICU.
