Sebring Convertible V6-2.7L (2009)
4. Position the wheel speed sensor cable routing clamp (4) on the outside frame rail (6) and install the mounting screw (3). Tighten the mounting
screw to 18 Nm (13 ft. lbs.).
5. Install the speed sensor cable routing clip (2) on the outside frame rail (6).
6. Insert the wheel speed sensor cable through the hole in the body (7) and install the grommet (1) in the hole.
7. Lower the vehicle.
8. Connect the wheel speed sensor cable connector (2) to the wiring harness connector (3) on top of the frame rail (1).
9. Perform the Diagnostic Verification Test and clear any faults. See: Brake Bleeding/Service and Repair
Rear
FRONT-WHEEL-DRIVE
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
