Sebring Convertible V6-2.7L (2009)
CAUTION: When removing the caliper guide pin bolts (2, 3) note that one has a special sleeve on the end. It is important that this bolt (3) be
installed in the upper mounting hole when the caliper is installed.
7. Remove the two brake caliper guide pin bolts (2, 3).
8. Slide and remove the disc brake caliper (1) with outboard brake pad attached from the disc brake adapter bracket, inboard brake pad and rotor.
9. Remove the outboard brake pad from the caliper by prying the brake pad retaining clip over the raised area on the caliper. Slide the brake pad off
of the brake caliper.
Front
INSTALLATION
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston
before installing the C-clamp to avoid damaging the piston.
CAUTION: Use care when installing the caliper (4) onto the adapter bracket (1) to avoid damaging the guide pin boots.
2. Install the disc brake caliper over the brake pads on the brake caliper adapter bracket.
NOTE: When installing the caliper guide pin bolts (2, 3) make sure that the one that has a special sleeve on the end is installed in the upper
mounting hole.
3. Align the caliper guide pin bolt holes with the adapter bracket. Install the upper (with special sleeve) (2) and lower (3) caliper guide pin bolts.
Tighten the guide pin bolts to 43 Nm (32 ft. lbs.).
