Sebring Convertible V6-2.7L (2009)
FRONT BRAKE ROTOR
NOTE: Inspect disc brake pads before installation. See: Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
1. Clean the hub face (1) to remove any dirt or corrosion where the rotor mounts.
2. Install the brake rotor (2) over the studs on the hub and bearing.
3. Install the disc brake caliper and adapter bracket assembly (1) over the brake rotor (4) and knuckle (2).
4. Install the mounting bolts (3) securing the caliper adapter bracket to the knuckle (2). Tighten the bolts to 108 Nm (80 ft. lbs.).
