Sebring Convertible V6-2.7L (2009)
5. If equipped with a wheel speed sensor, Install the wheel speed sensor head (3) into the rear of the hub and bearing (2). Install the wheel speed
sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).
6. Install the wheel cylinder onto the brake support plate. Install and tighten the mounting screws (1) to 13 Nm (115 in. lbs.).
7. Connect the brake tube (2) to the wheel cylinder (1). Tighten the tube nut to 17 Nm (150 in. lbs.).
8. Lubricate shoe contact areas on support plate and anchor using Mopar(R) Brake Lubricant or equivalent.
