Sebring Convertible V6-2.7L (2009)
9. Connect the two rear brake tubes (1, 2) to the proportioning valves on the master cylinder (3). Tighten the tube nuts to 20 Nm (177 in. lbs.).
10. Connect the two front brake tubes (1, 3) to the master cylinder (2). Tighten the tube nuts to 20 Nm (177 in. lbs.).
11. Connect the wiring harness connector (1) to the brake fluid level switch (2).
12. Connect the negative (ground) cable on the battery.
13. Fill the master cylinder reservoir to the proper level. See: Brake Fluid/Service and Repair
WARNING: Be certain a firm brake pedal is achieved prior to attempting to operate the vehicle. If a firm brake pedal cannot be achieved,
bleed the brake hydraulic system and check for leaks. See: Brake Bleeding/Service and Repair
