Sebring Convertible V6-2.7L (2009)
6. Remove the vacuum O-ring seal (2) from the master cylinder mounting flange (1).
Brake Master Cylinder - Assembly
ASSEMBLY
1. Install a NEW vacuum O-ring seal (2) on the master cylinder mounting flange (1) making sure the O-ring fits evenly against the mounting flange.
2. If the reservoir is being replaced, align the brake fluid level switch with its mounting hole on the left side of the master cylinder brake fluid
reservoir. Push the switch into the fluid reservoir until the switch retaining tabs (1) are expanded on the other side of the reservoir (2), locking it in
place.