Sebring Convertible V6-2.7L (2009)
3. Using Valve Spring Compressor 8215A (1) and Valve Spring Adapter 8216A (2), depress valve spring only enough to release tension on rocker
arm.
4. Remove rocker arm from cylinder head.
CAUTION: If rocker arms are to be reused, identify position of rocker arms for reassembly in their original positions.
5. Repeat procedure for each rocker arm removed.
6. Inspect the rocker arm for wear or damage See: Procedures.
Valve Rocker Arm - Installation
INSTALLATION
1. Lubricate rocker arms with clean engine oil before installation.
2. Rotate engine until cam lobe is on its base circle (heel) of rocker arm being installed.
3. Using Special Tools 8215A (1) and 8216A Adaptor, depress valve spring only enough to install rocker arm.
4. Install rocker arm in original position (if reused) over valve and lash adjuster. Release tension on valve spring.
NOTE: Inspect rocker arm for proper engagement into lash adjuster and valve tip.
5. Repeat procedure for each rocker arm being installed.
