Sebring Convertible V6-2.7L (2009)
Engine Mount: Service and Repair
Engine Mount Insulator - Installation
Left
INSTALLATION
1. Position mount to frame rail. Install mount to frame rail fasteners (8). Torque fasteners to 33 Nm (24 ft. lbs.).
2. Raise transmission into position with floor jack.
3. Install three vertical bolts from mount to transmission bracket (9). Torque fasteners to 61 Nm (45 ft. lbs.).
4. Remove floor jack and wooden block.
5. Install throttle body air inlet hose and air cleaner housing assembly.
6. Connect negative battery cable.
Rear
INSTALLATION
