Sebring Convertible V6-2.7L (2009)
1. Position rear mount on suspension crossmember and loosely install bolts.
2. Position mount bracket (2) on transaxle and install bolts. Tighten to 95 Nm (70 ft. lbs.).
3. Tighten rear mount to crossmember bolts to 61 Nm (45 ft. lbs.)
NOTE: Be sure the weight of the engine is static and in rest position.
4. Install rear mount to bracket through bolt (1) and tighten to 75 Nm (55 ft. lbs.).
5. Tighten front mount through bolt to 75 Nm (55 ft. lbs.)
6. Install throttle body air inlet hose and air cleaner housing assembly.
Front
INSTALLATION
1. Install front anti-roll mount bracket and start bolts.
