Sebring Convertible V6-2.7L (2009)
Engine Control Module: All Technical Service Bulletins
Engine Controls - PCM Update For Cruise Control Function
NUMBER: 18-028-10
GROUP: Vehicle Performance
DATE: October 16, 2010
HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING "HELP" THEN "HELP
CONTENTS" AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 11.01 OR HIGHER TO PERFORM THIS PROCEDURE.
StarMOBILE DESKTOP CLIENT MAY ALSO BE USED TO PERFORM THIS PROCEDURE.
SUBJECT:
Flash: Speed Control Operation Improvements
OVERVIEW:
This bulletin involves flash reprogramming the Powertrain Control Module (PCM) with new software.
MODELS:
2009-2010
(JC)
Journey
2007 - 2010
(JS)
Avenger/Sebring/Sebring Convertible
2008 - 2010
(RI)
Town & Country/Grand Voyager
NOTE:
This bulletin applies to RT vehicles equipped with a 6-speed automatic transmission (sales code DG2) built before September 15, 2010 (MDH 091
5XX).
NOTE:
This bulletin applies to JC vehicles equipped with a 6-speed automatic transmission (sales code DG2) built before September 28, 2010 (MDH
0928XX).
NOTE:
This bulletin applies to JS vehicles equipped with a 6-speed automatic transmission (sales code DG2) built before September 23, 2010 (MDH
0923XX).
SYMPTOM/CONDITION:
The speed control operation has changed to correct the following conditions:
i.
Adjust the set speed control to react when the speed drops to 2-3 MPH below the target.
ii. A RPM increase while going downhill due to a transmission downshift.
DIAGNOSIS:
Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as
designed. If DTC's are present record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
