Sebring Convertible V6-2.7L (2009)
Air Bag Control Module: Service and Repair
Occupant Restraint Controller Jumper Harness - Removal
ORC JUMPER HARNESS
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may
result in serious or fatal injury.
3. Remove the center console See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Shifter Housing - Removal.
4. Disconnect the ORC jumper harness (2) electrical connector at the ORC (4) and then the body harness (3).
