Sebring Convertible V6-2.7L (2009)
Seat Position Sensor: Service and Repair
Seat Track Position Sensor - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to
take the proper precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system capacitor to discharge before further service.
2. Reach under the rear edge of the front seat cushion to access the seat track position sensor on a bracket located on the inboard side near the rear of
the upper inboard seat track.
3. Disconnect the seat wire harness connector from the sensor connector receptacle.
4. Using a small screwdriver, hold the latch feature depressed while sliding the connector end of the sensor off of the bracket.
5. Remove the sensor from under the front seat.
