Sebring Convertible V6-2.7L (2009)
Seat Belt Retractor: Service and Repair
Seat Belt Retractor - Installation
Front
INSTALLATION
INSTALLATION- SEDAN
1. Connect wire harness connectors to retractor (5 - tensioner squib and seat belt switch).
2. Place retractor and belt assembly into position and install the mounting bolt to B-pillar. Tighten bolt to 52 Nm (38.5 ft. lbs.).
3. Install turning loop and bolt onto height adjuster (1). Tighten bolt to 52 Nm (38.5 ft. lbs.).
4. Feed end of seat belt (2) through B-pillar trim (3) and install B-pillar trim .
5. Place seat belt webbing anchor (3) into position on the seat cushion frame (4) and install the bolt (2). Tighten to 47 Nm (34.5 ft. lbs.).
6. Install the side shield/cover (1) to the seat belt anchor (3).
WARNING: Do not connect the battery negative cable See: Testing and Inspection . Serious or fatal injury may result if the system test is not
performed first.
INSTALLATION- CONVERTIBLE
