Sebring Convertible V6-2.7L (2009)
1. Move aside the luggage compartment carpet as necessary to access the wheel speed sensor cable connector.
2. Disconnect the wheel speed sensor cable connector (1) at the body wiring harness connector (2).
3. Raise and support the vehicle. See: Maintenance.
4. Remove the wheel mounting nuts (3), then the rear tire and wheel assembly (1).
5. Remove the grommet (2) from the hole in the body (1) and pull the wheel speed sensor cable out through the hole.
6. Remove the speed sensor cable routing clip (3) from the outside frame rail.
7. Remove the screw (4) fastening the cable routing clamp (5) to the rear suspension crossmember (6).
