Sebring Convertible V6-2.7L (2009)
16. Position the power steering hose routing clamps (2) on the crossmember. Install and tighten the screws to 8 Nm (71 in. lbs.).
17. Install the fore/aft crossmember (4) and front engine mount through-bolt See: Suspension/Cross-Member/Service and Repair/Crossmember -
Installation.
18. Install the rear engine mount See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount Insulator - Installation.
19. If equipped, install the engine belly pan.
NOTE: Prior to attaching the outer tie rod end to the knuckle, inspect the tie rod seal boot. If the seal boot is damaged, replace the outer tie
rod end.
20. On each side of the gear, install the outer tie rod end (6) into the hole in the knuckle (2) arm. Start a NEW tie rod mounting nut (3) onto the stud.
