Sebring Convertible V6-2.7L (2009)
4. Release the lower ball joint (3) from the lower control arm (1) using Remover (2) 9360. Do not lift the knuckle out of the lower control arm at this
time.
CAUTION: Upon removing the knuckle from the ball joint stud, do not pull outward on the knuckle. Pulling the knuckle outward at this point
can separate the inner C/V joint on the half shaft thus damaging it.
5. At each end of the stabilizer bar, while holding the stabilizer bar link (1) lower stud stationary, remove the nut (3) securing the link to the stabilizer
bar (2).
6. Rotate the ends of the stabilizer bar (2) upward away from the lower control arm.
7. Remove the front bolt (1) attaching the lower control arm (3) to the front suspension crossmember.