Sebring Convertible V6-2.7L (2009)
UP/DOWN ADJUSTMENT-FRONT DOOR GLASS
1. Lower the front door and quarter glass halfway down.
2. Using masking tape or equivalent, place tape as shown (1 and 2).
3. On the front window (2), measure and mark two lines, one at 7mm and another at 11mm from the top of the window.
4. Raise the windows to the full up position and close the doors with top fully closed.
5. The top lines on the tape should not be visible whereas the bottom line should be visible.
6. If adjustment of the front door window is required, remove the front door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Front Door Panel/Service and Repair/Front Door Trim Panel - Removal.
7. Remove the two access plug covers on the door module to gain access to the adjustment screws.
8. If the top line is visible, the window(s) must be adjusted up. If the bottom line is not visible the window must be adjusted down.
9. If the front of the glass must be adjusted, go to 10. If the rear of the glass must be adjusted, go to 11.
NOTE: One revolution of the adjustment screw equals 1mm.
10. At the front of the door, rotate the adjustment screw (2) clockwise (CW) to raise the glass. Rotate the adjustment screw counterclockwise (CCW)
to lower the glass.
