Sebring Convertible V6-2.7L (2009)
1. Raise the windows to the full up position and close the doors with top fully closed.
2. Inspect for gaps between the window and weather-strips.
3. Remove the door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door
Trim Panel - Removal.
4. Remove the four access plug covers on the door module to gain access to the adjustment screws.
NOTE: Do not loosen the cam nut. The inner allen slot is used for adjustment only.
NOTE: 180 degrees of rotation on the cam equals 20mm of glass movement.
5. If the glass must be adjusted inboard, rotate the inner cam (3) counterclockwise (CCW) for the left front door or clockwise (CW) for the right front
door.
6. If the glass must be adjusted outboard, rotate the inner cam CW for the left front door or CCW for the right front door.
7. Close the door and verify adjustments, if more adjustments are necessary repeat steps 5 and 6.
8. Install the two access plug covers on the door module.
9. Install the door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door
Trim Panel - Installation.
FORE/AFT AND UP/DOWN ADJUSTMENT-QUARTER GLASS
