Sebring Convertible V6-2.7L Flex Fuel (2008)
l.
Place the new switch into position and install a new rivet to secure the switch to the latch bracket.
m.
Install the latch and striker pad onto the latch bracket and install the retaining screws. Tighten the screws to 115 in. lbs. (13 N.m).
NOTE:
Be sure that the elongated hole on the bracket aligns with the elongated hole on the striker pad.
n.
Secure the gray connector to the deck lid forward latch retaining bracket (Figure 8).
o.
Tie strap the deck lid micro switch wiring harness to the retaining bracket (Figure 8).
p.
Place the latch bracket into position upside down on the vehicle. Then connect the latch release cable to the latch pawl and bracket anchor as
noted in Step 12g of this procedure (Figure 6).
CAUTION:
Incorrect installation of the latch release cable will prevent deck bar latching.
q.
Rotate the bracket to its right side up position.
r.
Line up the latch bracket using the marks made in Step 12a (Figure 5).
s.
Install the three latch bracket mounting screws and tighten them to 88 in. lbs. (10 N.m) (Figure 5).
t.
Connect the deck lid switch grey electrical connector to the gray body wiring harness connector.
u.
Install new tie straps to secure the body wiring harness to the forward latch bracket.
v.
Reconnect the negative battery cable.
>
If the vehicle DID NOT have RRT 07-025 performed AND the MDH is 062223 or earlier, continue with Step 13 of this procedure.
>
If the vehicle HAD RRT 07-025 performed OR the MDH is 062300 through 083023, continue with Step 19 of this procedure.
NOTE:
The appropriate part numbers for each VIN can be viewed on the DealerCONNECT VIP and Global Recall System functions.
13.
Using the StarSCAN, perform the following procedure to gain access to the extend and retract micro switches:
a.
Power up the StarSCAN and turn the key to the "ON" position.
b.
From the "HOME" screen select "ECU View".
