Sebring Convertible V6-2.7L VIN R (2003)
1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets as necessary (Fig. 31).
2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations as shown in (Fig. 30).
3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 Nm (105 in. lbs.).
4. Install ignition coils.
5. Install ignition coil capacitor and fastener.
6. Connect all electrical connectors and harness clips.
7. Install ground strap to cylinder head cover stud.
8. Install upper intake manifold.
9. Connect negative battery cable.
