Sebring Convertible V6-2.7L VIN R (2003)
1. Install air conditioning compressor/generator belt on pulleys, tensioner in slack position, slip belt over idler last (Fig. 8).
2. (Refer to - COOLING/ACCESSORY DRIVE/ DRIVE BELTS - ADJUSTMENTS) for proper drive belt tension adjustment.
3. Install belt splash shield and right front wheel.
4. Lower vehicle.
POWER STEERING PUMP BELT
1. Install power steering belt on pulleys (Fig. 8).
2. (Refer to - COOLING/ACCESSORY DRIVE/ DRIVE BELTS - ADJUSTMENTS) for proper drive belt tension adjustment.
3. Install air conditioning compressor/generator belt.
4. Install belt splash shield and right front wheel.
5. Lower vehicle.
ADJUSTMENT - 2.7L ACCESSORY DRIVE BELTS
NOTE: A belt is considered "used" after 15 minutes of run time.
AIR CONDITIONING COMPRESSOR/GENERATOR BELT TENSIONING
WARNING: DO NOT EXERT MORE THAN 190 Nm (140 ft. lbs.) OF FORCE ON AIR CONDITIONING COMPRESSOR/GENERATOR
BELT TENSIONER BRACKET DURING TENSIONING PROCEDURE.
NOTE: Ensure lower tensioner bracket bolt is finger tight/seated to prevent bending.
NEW BELT
