Sebring Convertible V6-2.7L VIN R (2003)
Muffler: Service and Repair
MUFFLER/PIPE ASSEMBLY
REMOVAL
WARNING: THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER
WORK AROUND OR ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE
SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER
RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.
1. Raise vehicle on hoist and apply penetrating oil to band clamp of component being removed.
2. Remove ground strap from muffler.
3. Loosen band clamp for muffler/pipe assembly.
CAUTION: Do not use any tools to remove the rubber isolators-remove by hand only. Soapy water or silicone-based lubricant spray may be used
to assist removal/installation of isolators. DO NOT use a petroleum-based lubricant on the isolators, as damage to the rubber material can occur.
