Sebring Convertible V6-2.7L VIN R (2003)
Constant Velocity Joint Boot: Service and Repair
Inner
INNER CV BOOT
REMOVAL
1. Remove large boot clamp, which retains inner tripod joint sealing boot to tripod joint housing and discard. Remove small clamp, which retains
inner tripod joint sealing boot to interconnecting shaft and discard. Remove the sealing boot from the tripod housing and slide it down the
interconnecting shaft.
CAUTION: When removing the tripod joint housing from the spider assembly, hold the bearings in place on the spider bunions to prevent the
bearings from falling away.
2. Slide the tripod joint housing off the spider assembly and the interconnecting shaft (Fig. 22).
