Sebring Convertible V6-2.7L VIN R (2003)
11. Remove 3rd gear blocker ring (Fig. 114).
12. Remove 3rd gear (Fig. 115).
13. Inspect third gear thrust washer for signs of excessive wear. To replace, drive off of input shaft with suitable drift and hammer.
ASSEMBLY
NOTE: When servicing the input shaft assembly, all snap rings MUST be replaced with new ones upon assembly. 5th gear nut must also be replaced.
NOTE: When installing 3/4 synchronizer hub to shaft, make sure to align oil slots on synchronizer hub face with oil hole in the shaft splined hub
journal.
