Sebring Convertible V6-2.7L VIN R (2003)
Seals and Gaskets: Service and Repair
AXLE SEALS
REMOVAL
1. Raise vehicle on hoist.
2. Remove one or both front halfshaft assemblies.
3. Using a suitable screwdriver, remove one or both axle seals (Fig. 61).
INSTALLATION
1. Using driver handle C-4171 and installer 8476, install axle seals into position (Fig. 62).
2. Install one or both front halfshaft assemblies.
3. Check transaxle fluid level and adjust if necessary.
4. Lower vehicle.
