Sebring Convertible V6-2.7L VIN R (2003)
7. Remove shift mechanism-to-floor pan bolts and remove mechanism (Fig. 103).
INSTALLATION
1. Install gear shift mechanism to floor pan (Fig. 103). Install and torque four (4)nuts to 25 Nm (18 ft. lbs.).
2. Install crossover and selector cables into position. Secure with retaining clips (Fig. 104).
NOTE: Only the crossover cable is adjustable. The selector cable does not have any adjustment capabilities.
3. Adjust crossover cable as follows:
a. Loosen adjusting screw on crossover cable at shifter (Fig. 104).
b. The gearshift mechanism and transaxle crossover lever are spring-loaded and self-centering. Alignment pins used in the past are not required
anymore. Allow gearshift mechanism and transaxle crossover lever to relax in their neutral positions. To ensure the gearshift lever is in the
proper position, place the shifter in 3rd or 4th gear if necessary. Torque adjustment screw to 8 Nm (70 in. lbs.). Care must be taken to avoid
moving the shift mechanism off-center during screw tightening.
c. Perform functional check by shifting transaxle into all gears.
4. Install center console assembly (Fig. 101).
5. Install gearshift knob/boot assembly. Ensure knob retaining tabs are secured to shift lever. Snap boot to console at retainer locations.
