Sebring Convertible V6-2.7L VIN R (2003)
3. Move the support spacers as necessary so that the top of the windshield aligns with the marks on the header, from the original windshield.
4. Place a piece of tape over the ratcheting portion of the bottom support spacer to prevent them from moving.
5. Repeat Step 3 and Step 4 for the opposite side of the windshield.
Fig. 4
6. Mark the glass at the support spacers with a grease pencil or pieces of masking tape and ink pen to use as a reference for installation (Fig. 4).
7. Remove replacement windshield from windshield opening.
Fig. 5
8. Position the windshield inside up on a suitable work surface with two padded, wood 10 cm by 10 cm by 50 cm (4 in. by 4 in. by 20 in.) blocks,
placed parallel 75 cm (2.5 ft.) apart (Fig. 5).
WARNING: DO NOT USE SOLVENT BASED GLASS CLEANER TO CLEAN WINDSHIELD BEFORE APPLYING GLASS PREP
AND PRIMER. POOR ADHESION CAN RESULT.
9. Clean inside of windshield with ammonia based glass cleaner and lint-free cloth.
10. Apply Glass Prep adhesion promoter 25 mm (1 in.) wide around perimeter of windshield and wipe with clean/dry lint-free cloth until no streaks
are visible.
11. Apply Glass Primer 25 mm (1 in.) wide around perimeter of windshield. Allow at least three minutes drying time.
12. Using a razor knife, remove as much original urethane as possible. Do not damage paint on windshield fence.
13. Apply pinch weld primer 15 mm (.75 in.) wide around the windshield fence. Allow at least three minutes drying time.
