Sebring LX Convertible L4-2.4L VIN X (2002)
Seat Heater: Testing and Inspection
Heated Seat Element
Refer to Heated Seat System for the location of the proper heated seat system diagnosis and testing procedures. To check the heated seat element and
sensor circuits, proceed as follows. The wire harness connectors for the seat cushion heated seat element and sensor and for the seat back heated seat
element are located under the seat, near the rear edge of the seat cushion frame. Refer to Wiring Diagrams for the location of complete heated seat
system wiring diagrams.
Fig.1 Seat Cushion Element Connector
Seat Cushion
1. Disconnect and isolate the battery negative cable. Disconnect the green 4-way heated seat wire harness connector. Using an ohmmeter, check for
continuity between pins A and B of the seat cushion wire harness connector. There should be continuity. If OK, test the seat back element as
described below. If not OK, check the green 2-way seat cushion connector. If OK, replace the faulty seat cushion cover and element assembly.
Seat Back
1. Disconnect and isolate the battery negative cable. Disconnect the green 2-way heated seat back wire harness connector. Using an ohmmeter, check
the resistance between the two pins. There should be continuity. If OK test the heated seat control module as described.If not OK replace the faulty
seat back cover and element assembly.