Sebring LX Convertible L4-2.4L VIN X (2002)
14. Adjust cable tension for the parking brake system using the following steps.
^
Position parking brake lever so it is in the fully released position.
^
Tighten the adjusting nut on the parking brake lever output cable until 26 mm millimeters of thread is out past top edge of adjustment nut.
^
Actuate the parking brake lever to its fully applied position (15 clicks) 1 time and then reposition the lever to its fully released position.
NOTE: Actuating the parking brake lever to its fully applied position one time after tightening the adjustment nut will yield (stretch) the bent nail
portion of the tension equalizer approximately 1/4 inch. This process will correctly set the parking brake cable tension.
15. Check the rear wheels of the vehicle with the park brake lever fully released, they should rotate freely without dragging.
16. After the park brake cable tension has been properly adjusted, check for free play in park brake lever. Park brake hand lever should feel firm at all
clicks, with a maximum of 15 clicks of lever travel possible.
17. Install the center floor console.
18. Install rear carpeting.
19. Install both rear door sill plate moldings by snapping them onto rear door sills.
20. Install lower rear seat cushion.
