Sebring LX Convertible L4-2.4L VIN X (2002)
Parking Brake Lever: Service and Repair
LEVER PARKING BRAKE
REMOVAL
1. Remove the floor console.
2. Lower parking brake lever handle.
3. Loosen adjusting nut on park brake lever output cable. This will take tension off output cable, allowing it to be easily removed from tension
equalizer.
CAUTION: Discard output cable retaining clip after removing it from park brake cable tension equalizer. Retainer is not to be re-used, a new
retainer is to be installed when attaching output cable to tension equalizer.
4. Using a screwdriver, unlatch the park brake output cable retainer, then remove cable retainer from park brake cable tension equalizer.
5. Remove the park brake cable tension equalizer from the park brake lever output cable.
6. Remove the electrical connector from the ground switch on the park brake lever mechanism.
7. Unclip the wiring harness from the park brake mechanism bracket.
